Lexus RC350 User Manual page 124

124
2. Instrument cluster
Suspension of the settings display
■
In the following situations, operation of the settings display will be temporarily sus-
pended.
When a warning message appears on the multi-information display
●
When the vehicle begins to move
●
Tire pressure
■
It may take a few minutes to display the tire inflation pressure after the engine switch is
●
turned to IGNITION ON mode. It may also take a few minutes to display the tire infla-
tion pressure after inflation pressure has been adjusted.
"---" may be displayed if the tire position information cannot be determined due to
●
unfavorable radio wave conditions.
Tire inflation pressure changes with temperature. The displayed values may also be dif-
●
ferent from the values measured using a tire pressure gauge.
When disconnecting and reconnecting battery terminals
■
The following information data will be reset:
Drive information
●
Lap timer: Measured lap times, history
●
G-force: Record of the maximum G-forces
●
Using the lap timer
■
If the engine is stopped while a lap is being timed, the lap timer will stop and the lap time
up to that point will be recorded.
Liquid crystal display
■
P. 104
WARNING
Caution for use while driving
■
When operating the multi-information display while driving, pay extra attention to the
●
safety of the area around the vehicle.
Do not look continuously at the multi-information display while driving as you may fail
●
to see pedestrians, objects on the road, etc. ahead of the vehicle.
The information display at low temperatures
■
Allow the interior of the vehicle to warm up before using the liquid crystal information
display. At extremely low temperatures, the information display monitor may respond
slowly, and display changes may be delayed.
For example, there is a lag between the driver' s shifting and the new gear number
appearing on the display. This lag could cause the driver to downshift again, causing
rapid and excessive engine braking and possibly an accident resulting in death or
injury.
Cautions during setting up the display
■
As the engine needs to be running during setting up the display, ensure that the vehicle
is parked in a place with adequate ventilation. In a closed area such as a garage,
exhaust gases including harmful carbon monoxide (CO) may collect and enter the
vehicle. This may lead to death or a serious health hazard.
RC350_RC300_RC200t_RC F_U (OM24671U)