Turning The Radiant 2500 Video Light On/Off - Fantasea Line Radiant 2500 Instruction Manual

5. It is recommended that you occasionally remove the black O-ring seals from the light,
wipe them with a soft, clean cloth and lubricate them with a small drop of the provided
silicone grease. Then carefully replace the O-ring prior to replacing the LED head.
6. The hand lanyard is pre-installed on your light. It can be easily removed and reinstalled as
needed. To install the Hand Lanyard, insert it through the Hand Lanyard Insert Slot on the
back of the light, then pull it through itself and test it in order to make sure it is secure.

TURNING THE RADIANT 2500 VIDEO LIGHT ON/OFF

1. To turn the light on, hold down the power button for 1.5 seconds.
2. Take special care not to stare into the light beam or shine it into the eyes of anyone else,
because the light is powerful and may damage ones' eyes.
3. The Radiant 2500 Video Light features 4 power output modes in the following order: 100%
power output, 50% power output, 25% power output and flashing mode. To switch
between the power output modes, simply push the power button for half a second. Each
time the power button is shortly pushed, the power mode is altered according to the
order of power modes as listed above.
4. To turn the light off, press the power button for 2 seconds. The light will flash three
times and then shut off.
5. The following diagram outlines the operation of the Radiant 2500 Video Light:
PUSH & HOLD BUTTON FOR 1.5 SEC
PUSH & HOLD BUTTON FOR 0.5 SEC
PUSH & HOLD BUTTON FOR 0.5 SEC
PUSH & HOLD BUTTON FOR 0.5 SEC
PUSH & HOLD BUTTON FOR 0.5 SEC
8
POWER OFF
100% POWER
50% POWER
25% POWER
FLASHING MODE
Fantasea Radiant 2500 Video Light Instruction Manual 20150126
PUSH & HOLD BUTTON
FOR 2 SEC