Table of Contents
Advertisement
5. When the Radiant 2500 Video Light is turned on, the colorful light around the power
switch button serves as a battery indicator and shows the battery charge level:
a. Green (100%-60% power)
b. Yellow (60%-30% power)
c. Red (30%-15% power)
d. Flashing Red (15%-1% power)
MOUNTING THE RADIANT 2500 VIDEO LIGHT ON AN ARM
1. The Y-S Connector included enables mounting the Radiant 2500 Video Light on any arm or
connector that features a standard YS Mount at the top, such as on Fantasea Flex Arms.
2. In order to install the Y-S Connector on the Radiant 2500 Video Light, first remove the
screw from the bottom of the YS Mount by unscrewing it all the way out (image #5).
3. Install the YS Mount by sliding it on the body of the light, starting from its rear end and all
the way towards the LED head, making sure that the hand lanyard doesn't interfere or get
caught between the light and the Y-S connector. Slide the connector over the rubber
sleeve and then all the way towards the LED head until it reaches a widening and can no
longer be slid forward (image #6). Note that the connector is flexible and might need to be
stretched a bit in order to be slid over the rubber sleeve.
4. With the Y-S Connector installed on the light, position it over the arm so that the Y-S
Mount on top of the arm is aligned with the YS Connector at the bottom of the LED light
(image #7).
5. Install the screw all the way through the Y-S Connector and Y-S Mount on the arm (image
#8). Tighten it enough to keep the LED light in a fixed position.
6. It is always advisable to secure the light using the hand lanyard.
9
Rubber sleeve
Image #5
Image #7
Fantasea Radiant 2500 Video Light Instruction Manual 20150126
Image #6
Image #8
Advertisement
Table of Contents
