Table of Contents
Advertisement
5. It is recommended that you occasionally remove the black O-ring seals from the light,
wipe them with a soft, clean cloth and lubricate them with a small drop of silicone grease.
Then carefully replace the O-ring prior to replacing the LED head.
6. The hand lanyard can be easily removed and reinstalled as needed. To install the Hand
Lanyard, insert it through the Hand Lanyard Insert Slot on the back of the light, then pull it
through itself and test it in order to make sure it is secure.
TURNING THE RADIANT 1000X LIGHT ON/OFF
1. To turn the light on, hold down the power button for 1.5 seconds.
2. Take special care not to stare into the light beam or shine it into the eyes of anyone else,
because the light is powerful and may damage ones' eyes.
3. The Radiant 1000X Light features 6 power output modes in the following order: 100%
power output, 50% power output, 25% power output, red light, flashing light and SOS. To
switch between the power output modes, simply push the power button for half a second.
Each time the power button is shortly pushed, the power mode is altered according to the
order of power modes as listed above.
4. To turn the light off, press the power button for 2 seconds. The light will flash three
times and then shut off.
5. The following diagram outlines the operation of the Radiant 1000X Light:
PUSH & HOLD BUTTON FOR 1.5 SEC
PUSH & HOLD BUTTON FOR 0.5 SEC
PUSH & HOLD BUTTON FOR 0.5 SEC
PUSH & HOLD BUTTON FOR 0.5 SEC
PUSH & HOLD BUTTON FOR 0.5 SEC
PUSH & HOLD BUTTON FOR 0.5 SEC
7
POWER OFF
100% POWER
50% POWER
25% POWER
RED LIGHT
FLASHING MODE
SOS MODE
Fantasea Radiant 1000X Dive & Video Light Instruction Manual 20151228
PUSH & HOLD BUTTON
FOR 2 SEC
Advertisement
Table of Contents
