Page 1
For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.com 7213880100R00...
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. W ARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com...
Welcome & Congratulations Thank you and congratulations for purchasing an Optimyst stove from ® Dimplex. Please use our convenient online registration page to record your model and serial numbers for future reference at www.dimplex.com/register Model Number Serial Number Please carefully read and save these instructions.
Do not use in areas where gasoline, damaged in any manner. Contact paint, or flammable liquids are used Dimplex Technical Service at or stored or where the unit will be 1-888-346-7539. exposed to flammable vapors.
IMPORTANT INSTRUCTIONS by the manufacturer may cause ⑳ The stove must not be located fire, electric shock or injury to directly below a socket outlet. persons. ㉑ The stove must be positioned ⑮ To reduce the risk of electric so that the plug is accessible. shock, this appliance must be WARNING: Remote control grounded.
A dedicated circuit will be required if, after installation, the circuit breaker trips or the fuse blows on a regular basis when the heater is operating. Additional ap- pliances on the same circuit may exceed the current rating of the circuit breaker. www.dimplex.com...
Assembly 1. Carefully unpack all of the 5. Orient transducer wire so that components from the box. it does not sit directly above (Figure 1) the emitter and the wire passes through the slot in the 2. Remove top cover by turning side of the tank.
Page 8
8. Install the logset on top, so that the opening is not blocked. 9. Make sure the On/Off switch is switched to Off (refer to Operating Instruction section). 10. Plug the unit into a 15 Amp/ 120 volt outlet. www.dimplex.com...
Operation individual requirements, turn Figure 4 the thermostat control clock- wise all the way to turn on the heater. When the room reaches the desired temperature, turn the thermostat knob counter- clockwise until you hear a click. Leave thermostat in this position to maintain the room temperature at this setting.
Off, using either the CAUTION: If you need to con- momentary button, on the unit, tinuously reset the heater, unplug or the Off button on the remote the unit and call Dimplex North control, then back on to return www.dimplex.com...
Page 11
Operation to Level 1 - Logs and Light only Figure 5 operation. Battery Replacement To replace the battery: Flame 1. Slide battery cover open on Button the remote control (Figure 5). Standby Button 2. Install two 1.5 Volt (AAA) bat- Heat tery in the battery holder.
1/8 tsp of salt (0.5 2. View the lamps from a dis- mL) added to the water reservoir. tance in front of the fire and (The addition of additional salt observe which lamp needs to should only be when you notice www.dimplex.com...
Page 13
Filter ! NOTE: Replacement light Sump bulbs can be obtained by contact- Filter Cleaning ing Dimplex Customer Service at 1-888-346-7539. The air filter can be removed and gently rinsed with water to 6. Carefully insert the two pins clean and dried on a towel before of the new bulb into the two reinstalling.
What Dimplex will do in the event of a with the purchaser, and in the event of a defect...
Page 15
Warranty practicable or cannot be timely made, IN CONNECTION WITH THE SALE, Dimplex may, in lieu of repair or MAINTENANCE, USE, OR INABILITY TO replacement, choose to refund the USE THE PRODUCT, EVEN IF DIMPLEX purchase price for such product or OR ITS DIRECTORS, OFFICERS, OR part.