Electrical Hazards; Fire Hazards; Explosion Hazards - Generac Power Systems rtg16eza1 Owner's Manual

Automatic transfer switch
Hide thumbs Also See for rtg16eza1:
Table of Contents

Advertisement

Electrical Hazards

DANGER
Electrocution. Contact with bare wires,
terminals, and connections while generator
is running will result in death or serious injury.
DANGER
Electrocution. Never connect this unit to the electrical
system of any building unless a licensed electrician
has installed an approved transfer switch. Failure to
do so will result in death or serious injury.
DANGER
Electrical backfeed. Use only approved switchgear to
isolate generator when electrical utility is the primary
power source. Failure to do so will result in death,
serious injury, and equipment damage.
DANGER
Electrocution. Verify electrical system is
properly grounded before applying power.
Failure to do so will result in death or serious
injury.
DANGER
Electrocution. Do not wear jewelry while
working on this equipment. Doing so will
result in death or serious injury.
DANGER
Electrocution. Water contact with a power
source, if not avoided, will result in death
or serious injury.
DANGER
Electrocution. Contact with bare wires,
terminals, and connections while generator
is running will result in death or serious injury.
DANGER
Electrocution. In the event of electrical accident,
immediately shut power OFF. Use non-conductive
implements to free victim from live conductor. Apply
first aid and get medical help. Failure to do so will
result in death or serious injury.
Installation Guidelines For 60 Hz Air-cooled Generators
Section 1: Safety Rules & General Information

Fire Hazards

(000144)
For fire safety, the generator must be installed and
maintained properly. Installation must always comply
with
regulations. Adhere strictly to local, state and
national electrical and building codes. Comply with
(000150)
regulations the Occupational Safety and Health
Administration (OSHA) has established. Also, verify
that the generator is installed in accordance with the
manufacturer's instructions and recommendations.
Following proper installation, do nothing that might
alter a safe installation and render the unit in
noncompliance with the aforementioned codes,
(000131a)
standards, laws and regulations.
Keep a fire extinguisher near the generator at all
times. Extinguishers rated "ABC" by the National
Fire Protection Association are appropriate for use
on the standby electric system. Keep the
extinguisher properly charged and be familiar with
its use. Consult the local fire department with any
(000152)
questions pertaining to fire extinguishers.

Explosion Hazards

(000188)
Connection of fuel source must be done by a qualified
professional technician or contractor. Incorrect installation
of this unit will result in death, serious injury, and damage
(000104)
to equipment and property damage.
Risk of fire. Allow fuel spills to completely dry
before starting engine. Failure to do so will
(000144)
result in death or serious injury.
Risk of Fire. Hot surfaces could ignite
combustibles, resulting in fire. Fire could
result in death or serious injury.
(000145)
WARNING
Risk of Fire. Unit must be positioned in a
manner that prevents combustible material
accumulation underneath. Failure to do so
could result in death or serious injury.
applicable
codes,
standards,
DANGER
DANGER
DANGER
WARNING
(000147)
laws
and
(000192)
(000151)
(000174)
(000110)
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rtg12eza1Rtg10eza1

Table of Contents