*
If a portable generator is used to power electrical load circuits normally powered by a utility
power source, it is required by code to install a transfer switch. The transfer switch must
effectively isolate the electrical system from the utility distribution system when the generator
is operating. Failure to isolate an electrical system by such means may result in damage to the
generator and may also result in injury or even death to utility power workers due to backfeed
of electrical energy.
After the transfer switch has been installed, do nothing that might render the installation in non-
compliance with such codes, standards, and regulations. Every effort was made to ensure that
the information in this manual was both accurate and complete at the time it was released.
However, the manufacturer reserves the right to change, alter, or otherwise improve this product
at any time without notice.
NOTE TO INSTALLER: Please leave this guide with the consumer for future reference. READ THIS MANUAL IN ITS
ENTIRETY BEFORE ATTEMPTING TO INSTALL THIS EQUIPMENT.
Generac® transfer switches should be installed by a professional electrician familiar with electrical wiring and
codes, and experienced in working with generators. Generac accepts no responsibility for accidents, damages or
personal injury caused by incorrect installation. This transfer switch is intended for surface mounting OUTDOORS.
Our transfer switches are UL listed to UL Standard 1008 and meet the criteria of National Electrical code Article
702.6 for Optional Standby Systems.
If using the generator and transfer switch for larger appliances, such as electric water heaters, clothes dryers, elec-
tric ranges and small air conditioners, check the labels on the appliances to be sure they do NOT exceed the rating
of the generator. No appliance should have an amperage rating that exceeds the individual breaker rating in the
transfer switch (30 or 50 Amps).
Transfer Switch Installation Guidelines
iii
Need help?
Do you have a question about the 6379 and is the answer not in the manual?