Connecting And Disconnecting In Audio Interface Mode - Zoom R16 Manual

Connecting and disconnecting in audio interface mode

This is a brief overview of connecting and disconnecting when a computer is hooked to the R16
by USB cable. For details, please refer to the separately attached "Cubase LE Startup Guide".
Connecting the R16 to the
computer for the first time
1
Install Cubase LE DAW software
on the computer
2
Download the latest ZOOM R16 /
R24 audio driver from the ZOOM
website (see below).
3
Install the audio driver on the
computer.
Install/setup details
Reference: "Cubase LE Startup Guide"
4
Connect the R16 to the computer.
R16 setup and connection
5
Setup DAW software
☞ Reference: "Cubase LE Startup Guide"
Control surface setup (Mackie Control) P.7
NOTE
The ZOOM R16/R24 audio driver is essential
for using the R16 as an audio interface for DAW
software such as Cubase LE.
When downloading, follow the included instruction
guide to install correctly.
Please download the latest R16 audio
driver from Zoom Corporation's website
at (http://www.zoom.co.jp).
5
Device setup
R16 setup and connection
Follow these procedures from the second time connecting
1
Press [USB].
2
Select >AUDIO INTERFACE .
U S B
> A U D I O I N T E R F A C E
Press [Enter].
3
Verify.
A U D I O I N T E R F A C E
E n t e r ?
Press [Enter].
4
Select "Continue."
S E T T I N G ?
[ C O N T I N U E ] R E S E T
Press [Enter].
NOTE
• Set the recording quantization (bit depth) of
Cubase LE or the DAW software that you are
using to 24-bit in order to achieve the best audio
quality when recording. (See the software manual
for how to make this setting.)
Change
menu
Change
menu