Onkyo TX-RZ1100 Basic Manual page 59

> Specifications > Settings
Setting Item Default Value
Auto Reconnect On
Pairing
‐
Information
Device
‐
Status
‐
• Wait for a while if "Bluetooth" cannot be selected. It will appear when the BLUETOOTH function is
started up.
> Listening Modes > Playback Function
Setting Details
This function automatically reconnects to the
BLUETOOTH enabled device connected last
when you change the input to "BLUETOOTH".
"On": Use this function
"Off": Do not use this function
• This may not work with some BLUETOOTH
enabled devices.
You can initialize the pairing information saved on
this unit.
Pressing ENTER when "Clear" is displayed
initializes the pairing information stored in this unit.
• This function does not initialize the pairing
information on the BLUETOOTH enabled
device. When pairing the unit again with the
device, be sure to clear the pairing information
on the BLUETOOTH enabled device in
advance. For information on how to clear the
pairing information, refer to the BLUETOOTH
enabled device's instruction manual.
Displays the name of the BLUETOOTH enabled
device connected to the unit.
• The name is not displayed when "Status" is
"Ready" and "Pairing".
Displays the status of the BLUETOOTH enabled
device connected to the unit.
"Ready": Not paired
"Pairing": Paired
"Connected": Successfully connected
■ 4� Power Management
Setting Item Default Value
Sleep Timer Off
Auto Standby On/Off
Auto Standby in Off
HDMI Standby
Through
> Basic Manual
Troubleshooting Appendix Troubleshooting | Appendix
Setting Details
Allows the unit to enter standby automatically when
the specified time elapses. Select a value from "30
minutes", "60 minutes", and "90 minutes".
"Off": Does not turn the unit to standby
automatically.
This setting places the unit on standby
automatically after 20 minutes of inactivity without
any video or audio input. (When "Network Standby"
is on, this becomes the HYBRID STANDBY mode
which reduces the increase in power consumption
to a minimum.)
"On": The unit will automatically enter standby
mode ("AUTO STBY" will light).
"Off": The unit will not automatically enter standby
mode.
• "Auto Standby" is displayed on the display and
TV screen 30 seconds before the Auto Standby
comes on.
• "Auto Standby" does not work when Zone 2/
Zone 3 is active.
• Default values vary depending on the regions.
Enable or disable "Auto Standby" while "HDMI
Standby Through" is on.
"On": The setting will be enabled.
"Off": The setting will be disabled.
• This setting cannot be set to "On" if "Auto
Standby" and "HDMI Standby Through" are set
to "Off".
|
23