Onkyo TX-RZ1100 Basic Manual page 46

> Specifications > Settings
2� Speaker
You can make changes to the connection environment of the speakers and change the
volume level. Settings are automatically configured if you use AccuEQ Room Calibration.
This setting cannot be selected if headphones are connected or audio is output from the
speakers of the TV.
■ 1� Configuration
Setting Item Default Value
Speaker 7.1.2 ch
Channels
Subwoofer 2ch
10
> Listening Modes > Playback Function
Setting Details
Select "2.1 ch", "3.1 ch", "4.1 ch", "5.1 ch", "6.1
ch", "7.1 ch", "2.1.2 ch", "3.1.2 ch", "4.1.2 ch",
"5.1.2 ch", "6.1.2 ch", "7.1.2 ch", "4.1.4 ch", "5.1.4
ch", "6.1.4 ch", or "7.1.4 ch" to suit the number of
speaker channels connected.
• This unit consists of a 9 ch amplifier, so with
"6.1.4 ch" or "7.1.4 ch" selected, use an analog
audio cable to connect the power amplifier to
the PRE OUT BACK jacks on this unit, then
connect the surround back speakers to the
power amplifier.
Set the PRE OUT SUBWOOFER jacks which
output audio signals.
"1ch": Only the PRE OUT SUBWOOFER 1 jacks
output audio signals.
"2ch": Both the PRE OUT SUBWOOFER 1 jacks
and the PRE OUT SUBWOOFER 2 jacks output
audio signals.
"No": Neither the PRE OUT SUBWOOFER 1 jacks
nor the PRE OUT SUBWOOFER 2 jacks output
audio signals.
Setting Item Default Value Setting Details
Height 1 Speaker Top Middle Set the speaker type if height speakers are
connected to the HEIGHT 1 terminals. Select
"Front High", "Top Front", "Top Middle", "Top
Rear", "Rear High", "Dolby Speaker (Front)",
"Dolby Speaker (Surr)", or "Dolby Speaker (Back)"
according to the type and layout of the connected
speakers.
> Basic Manual
Troubleshooting | Appendix
• This setting cannot be selected under any of
following conditions. Set the height speakers
type to "Height 2 Speaker".
– "Bi-Amp" is set to "Yes"
– "Zone Speaker" is set to "Zone 2/Zone 3"
• When two sets of height speakers are being
used, "Top Rear", "Rear High", "Dolby Speaker
(Surr)", and "Dolby Speaker (Back)" cannot be
selected
• "Dolby Speaker (Surr)" and "Dolby Speaker
(Back)" can only be selected when surround
speakers or surround back speakers are being
used, respectively. You can check speakers
that you are using on the figure displayed in
"Speaker Channels".
• If an item cannot be selected even though
connection is correct, check that the settings
in "Speaker Channels" matches the number of
connected channels.