Table of Contents
Advertisement
MAIN BOARD, OPTICAL PICK-UP SECTION (CDM-3021EBG)
2 saranet cushion
S804
Note on installation MAIN board:
When installing MAIN board,
adjust the S803, S804 and
knob (AV, HOLD).
knob (HOLD)
q; spacer (MD)
6 cushion
7 connector
(CN503)
3 terminal board (relay), battery
S803
knob (AV)
q; spacer (MD)
Note: Do not apply an excessive force
when removing an adhesive sheet
from the optical pick-up flexible board.
optical pick-up
4 Holding up the optical pick up section
flexible board
a little, remove the adhesive sheet.
Note: When the optical pick-up flexible board is removed,
fix it with new adhesive sheets, and when fixing the
optical pick-up flexible board, do it with two pieces
of adhesive sheets as shown in the figure.
qa optical pick-up section
(CDM-3021EBG)
8 optical pick-up flexible board
(CN501)
7 connector
(CN502)
9 MAIN board
– 9 –
1 tapping screw (B) (1.4 × 3)
5 Hold up both the optical pick-up
section and the main board at
the same time.
Note: Be careful to hold them up
because the optical pick-up
flexible board is still connected
to the main board.
optical pick-up
flexible board
two adhesive sheets
q; spacer (MD)
Advertisement
Table of Contents
