Table of Contents
Advertisement
5-6.
SCHEMATIC DIAGRAM – MAIN Board – •
See page 29 for Waveforms.
•
See page 12 for IC Block Diagrams.
– 25 –
– 26 –
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
specified.
•
%
: indicates tolerance.
• C : panel designation.
Note:
The components identi-
fied by mark 0 or dotted
line with mark 0 are criti-
cal for safety.
Replace only with part
number specified.
• A : B+ Line.
• U : B+ Line.
• Total current is measured with CD installed.
• Power voltage is dc 4.5 V and fed with regulated dc power
supply from DC IN jack (J401).
• Voltages and waveforms are dc with respect to ground in
playback mode.
no mark : CD PLAY
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
J
: CD PLAY (ANALOG OUT)
c : CD PLAY (OPTICAL OUT)
– 27 –
D-E888/E999/EJ825/EJ925
1
/
W or less unless otherwise
4
Note:
Les composants identifiés par
une marque 0 sont critiques
pour la sécurité.
Ne les remplacer que par une
pièce por tant le numéro
spécifié.
– 28 –
Advertisement
Table of Contents
