Installing The Flydvb Trio - LifeView FlyDVB Trio User Manual

3.2 Installing the FlyDVB Trio

1. Switch off your PC and all connected peripheral devices such as your printer and
monitor. Leave the AC power cable connected for the time being, so that your
computer is still grounded.
2. Touch the metal chassis at the rear of the PC to ground and to discharge static.
Now unplug the cord from the AC power socket.
3. Remove the cover from the case of your PC.
4. Look for a free PCI expansion slot. When selecting the PCI slot, note that TV cards
should not be plugged into PCI slot 1 in conjunction with an AGP graphics card
because PCI slot 1 is very frequently assigned to the same interrupts as the AGP
slot. This would give both cards the same interrupt, which can lead to crashes
during operation!
(This is usually the PCI slot closest to the AGP slot, but always check your
mainboard manual).
5. Carefully remove the card from its packaging and pick it up by the edges with one
hand while your other hand is touching a metal part of the PC. This will ensure that
your body is completely discharged via your computer without damaging the TV
card.
6. Align the holder at the rear of the TV card in the expansion slot in such a way that
the card's connectors are directly in line with the slot's socket.
7. Push the TV card firmly into the slot, ensuring good contact.
8. Fasten the TV card with an appropriate screw.
9. Reinstall the cover of your PC case.
10. Connect your satellite dish LNB to the DVB-S port. Connect your digital antenna to
the DVB-T port. Connect the antenna cable (which you would normally connect to
the antenna input terminal on your television) to the TV port. Reconnect the AC
power cable as well as all other cables. Make sure that your speakers are set to
low volume.
Installation
5