Hach HIAC PODS Basic User Manual page 16

Delete or print data
Use the buffer menu to delete or print the buffer contents.
1. Push F2 (DEL BUF) to delete the entire buffer contents. The
instrument shows a confirmation message and asks for the operation
to be accepted or cancelled.
2. Push F3 (PRT BUF) to print the entire buffer contents. The
instrument shows a confirmation message and asks for the operation
to be accepted or cancelled.
3. Push F1 (DEL SMP) or F2 (PRT SMP) while in the average count
(AVG CNT) menu to delete or print an individual sample test result.
When a sample selection is shown, the average count menu is
available.
See the sample data
When a sample selection is made, the instrument shows the sample
statistics for that particular sample. Push the average count (AVG CNT)
function key to see the remainder of the sample data.
Maintenance
D A N G E R
Multiple hazards. Only qualified personnel must conduct the tasks
described in this section of the document.
W A R N I N G
Personal injury hazard. Never remove covers from the instrument. This
is a laser-based instrument and the user risks injury if exposed to the
laser.
Clean the instrument
C A U T I O N
Fire hazard. Do not use flammable agents to clean the instrument.
16 English
N O T I C E
Make sure not to bend the pick-up tube or scratch the lower end where the seal
connection is made. Damage causes leakage or misalignment with the online
adapter.
1. Clean the instrument with a cleaning brush and a clean glycol base
solution.
2. Flush the instrument.
Change the filter
To remove the filter, refer to Figure 5.