Troubleshooting And Maintenance; Maintenance And Cleaning - THOMSON DVD80K User Manual

TROUBLESHOOTING AND MAINTENANCE

Consult the following table if there is a problem with the appliance.
Problem
Image with no sound
No sound and no image
Sound without image
Poor quality image or
sound

MAINTENANCE AND CLEANING

• Unplug the appliance before cleaning it.
• Remove fingerprints and dust with a soft and slightly damp cloth. Do not use abrasive products or solvents that may
damage the appliance's surface.
ATTENTION: Never immerse the appliance in water or in any liquid whatsoever.
• If it is not used for a long time, unplug the appliance and remove the batteries.
EN 30
Solutions
• Make sure the audio connections are
tight.
• Make sure the audio connectors are
not damaged.
• Check the volume on VOL/CH section.
• Make sure the audio parameters of the
player have been correctly set.
• Make sure the audio parameters of the
player have been correctly set.
• Make sure the sound is on.
• Make sure the system is ON.
• Make sure the supply cable is properly
connected.
• Check the supply cable plug is
correctly connected to the mains socket.
• Verify the LED light turns on.
• Verify the connections.
• Make sure the video cable is properly
connected to the TV video input (and not
to an audio output).
• Make sure the TV video input selected
is the correct one.
• Make sure the video connectors are
not damaged.
• Make sure the TV parameters have
been correctly set.
• Make sure the TV audio and video
parameters have been correctly set.
• Make sure the disk is in good condition
and free from scratches.
• Verify the AV connectors are in good
condition.
DVD PLAYER
DVD80K
Problem
The remote
control is not
working
"No disk"
appears
No sound
Dark image
Solutions
• Check the remote control
batteries.
• Point the remote control
towards the player's IR
receiver.
• Remove any obstacles
between the remote control
and the player.
• Make sure a disk has
been inserted in the player.
• Make sure the disk is
correctly inserted.
• Make sure the disk is in
good condition, free from
dust and scratches.
• Check the volume
and see if it is set at the
minimum level.
• Make sure the disk is in
good condition, free from
stains and scratches.
• Make sure the
microphone cable is
properly connected to one
of the microphone outputs.
• Check the ON/OFF
microphone switch and
make sure it is set to ON.
• A pair of earphones has
been connected to the unit.
• Adjust brightness and
contrast