Whirlpool W10730921A User Instructions page 7

On one side of the wiring connector, insert the screwdriver
blade between the connector tab and the connector to
release. Repeat for the opposite side. Pull the wiring
connector apart.
4. Remove the drawer front.
Push up on the lever at the bottom of the drawer glide
bracket to release the drawer front from the bracket.
Lift the drawer front up and off the drawer glide brackets.
A. Drawer glide bracket
5. Slide the drawer glides back into the refrigerator.
Replace the Drawer Fronts
1. Pull out the drawer glides until they are fully extended.
2. Push up on the lever at the bottom of the drawer glide bracket
to open. Insert the drawer front bracket into the drawer glide
bracket and release the lever.
NOTE: It helps if one person holds the drawer glides steady
while another person aligns the drawer front and connects the
brackets.
B. Release lever
3. Left-hand drawer only, reconnect wiring.
Align the two ends of the wiring connector and push them
together until you hear a "click" sound and feel the tabs
snap into place on the connector.
Gently pull on the wiring connection to ensure the wiring
connection is completely seated. Replace the wiring
cover.
NOTE: The wiring connection must be complete for the
drawer temperature control to operate.
4. Left-hand drawer only, replace the wiring connection cover.
5. Replace the drawer bins onto the drawer glides with the rear
side of the bin facing the back of the refrigerator as shown.
IMPORTANT: The Door Ajar alarm will sound if the interior
drawer bins are not replaced correctly. The bins are designed
with a specific front and rear. They must be placed into the
drawers, as shown, so that the refrigerated drawers will close
and operate properly.
A
B
B
A. Faces back of refrigerator (insert first)
B. Faces front of refrigerator
A
7 7 7 7 7 7