Whirlpool W10730921A User Instructions page 23

A
A. 1 cup of water
5. When Measured Fill calibration has been confirmed the icons will
disappear and the display will return to the home screen.
Dispensing
Press ICE/WATER to toggle through the following choices in a
continuous loop:
Water (default) - Dispenses water
Cubed - Dispenses cubed ice.
Crushed - Dispenses crushed ice.
NOTES:
The word "ICE" appears on the display screen when either
crushed or cubed ice is selected.
For crushed ice, cubes are crushed before being dispensed.
This may cause a slight delay when dispensing crushed ice.
Noise from the ice crusher is normal, and pieces of ice may
vary in size.
When changing from crushed to cubed, a few ounces of
crushed ice will be dispensed along with the first cubes.
Water
The Water Dispenser
IMPORTANT:
Dispense at least 1 qt (1 L) of water every week to maintain a fresh
supply.
If the flow of water from the dispenser decreases, it could be
caused by low water pressure.
With the water filter removed, dispense 1 cup (237 mL) of
water. If 1 cup (237 mL) of water is dispensed in 8 seconds or
less, the water pressure to the refrigerator meets the minimum
requirement.
If it takes longer than 8 seconds to dispense 1 cup (237 mL) of
water, the water pressure to the refrigerator is lower than
recommended. See "Water Supply Requirements" and
"Troubleshooting" for suggestions.
To Dispense Water (Standard):
1. Select water.
2. Press a sturdy glass against the dispenser paddle.
3. Remove the glass to stop dispensing.
Crushed Cubed
To Dispense Water (Measured Fill):
Measured Fill allows you to dispense a specified amount of water with
the touch of a few controls.
NOTE: The amount of water you select will be dispensed. Be sure that
the container is empty and can hold the entire volume. If ice is in the
container, you may need to adjust your selection.
1. Press MEASURED FILL to turn on the feature. When the feature is
on, the Measured Fill screen appears on the display.
NOTES:
The dispenser will automatically turn off Measured Fill after
1 minute of inactivity. When Measured Fill is turned off, any
changes you have made will be lost and all defaults will be
restored.
Press ICE/WATER, under "Back," to manually turn off the
Measured Fill feature and return to the Home screen.
2. Press LIGHT, under Units, to toggle among ounce, cup and liter.
The default unit is ounce.
Default, minimum, and maximum volumes are listed in the
following chart:
Units Default
Ounces 8
Cups 1
Liters 0.25
3. Press LOCK or OPTIONS to adjust the water volume as desired.
The LOCK control increases the volume, and the OPTIONS control
lowers the volume.
NOTES:
When increasing or decreasing the dispense volumes, if an
adjustment button (-/+) is held for approximately 10 seconds or
longer the control may stop responding. Release the button for
approximately 2 seconds and then continue making the
adjustment.
Most coffee cups (commonly 4 to 6 oz [118 to 177 mL] per
cup) are not the same size as a measuring cup (8 oz [237 mL]).
You may need to adjust the volume to avoid unintentionally
overfilling coffee cups.
4. Dispense water.
NOTE: While dispensing water, the digital display will count down
how much water remains to be dispensed, according to the
volume you selected. The flow of water will automatically stop
once the desired volume has been dispensed.
Press a sturdy glass against the dispenser paddle.
Place the glass below the water dispenser and press
MEASURED FILL, under Dispense, for hands-free dispensing.
Minimum Maximum
1 128
¹/₄ 16
0.05 4.00
OR
23 23