Remove And Replace Drawer Fronts - Whirlpool W10730921A User Instructions

Do not remove the two locator screws. These screws will
help you align the hinge when you replace the door.
A
C
³⁄₁₆
A. " Internal hex head screws
B. Ground wire (do not remove)
5. Lift the refrigerator door from the bottom hinge pin. The top
hinge will come away with the door.
NOTE: It may not be necessary to remove the bottom hinges
and brake feet assemblies to move the refrigerator through a
doorway.
Only if necessary, use a driver with a #2 square bit tip to
remove the bottom hinges and a ³⁄₈" nut driver to remove
the brake feet screws.
Replace Refrigerator Doors
Replace Right-Hand Door
1. Set the right-hand door onto the bottom hinge pin.
2. Insert the top hinge pin into the open hole in the top of the
refrigerator door.
3. Using the two ³⁄₁₆" internal hex head screws, fasten the hinge
to the cabinet. Do not tighten the screws completely.
Replace Left-Hand Refrigerator Door
IMPORTANT: Do not intertwine the water tubing and wiring
bundles when reconnecting them.
1. Set the left-hand door onto the bottom hinge pin.
2. Using the two ³⁄₁₆" internal hex head screws, fasten the hinge
to the cabinet. Do not tighten the screws completely.
3. Reconnect the water dispenser tubing.
Style 1 - Insert the tubing into the fitting until it stops and the
outer ring is touching the face of fitting.
Style 2 - Insert the tubing firmly into the fitting until it stops.
Close the clasp around the tubing. The clasp snaps into place
between the fitting and the collar.
4. Reconnect the electrical wiring.
Push together the two sections of the wiring plug.
Final Steps
1. Completely tighten the four internal hex head screws (two on
the right-hand door hinge and two on the left-hand door
hinge).
2. Replace both top hinge covers.
6 6 6 6 6 6
B
C. Locator screws (do not
remove)

Remove and Replace Drawer Fronts

Depending on the width of your door opening, it may be
necessary to remove the drawer fronts to move the refrigerator
into your home.
IMPORTANT:
If the refrigerator was previously installed and you are moving
it out of the home, before you begin, turn the refrigerator
control OFF, and unplug the refrigerator or disconnect power.
Remove food from the drawers.
Two people may be required to remove and replace the
drawer fronts.
Tools Needed: Flat-blade screwdriver
Refrigerated Drawers
Remove the Drawer Fronts
1. Open the drawer to its full extension. Grasp the sides of the
interior bin, and then lift up and out to remove.
2. Left-hand drawer only, remove the wiring connection cover.
Press in on the side of the cover to release the tab from the
slot, and then pull the cover away from the bracket.
A
B
A. Cover tab
B. Wiring connection cover
3. Left-hand drawer only, disconnect the wiring.
NOTE: The drawer front of the left-hand refrigerated drawer is
connected to the temperature control by wires running
underneath the drawer glide. Before removing the drawer
front, the wires must be disconnected.