LevelOne FBR-1405TX User Manual page 56

Client PC Service
Protocol
Port Range
Scheduling Rule
Click <Apply> at the bottom of the screen to save the above configurations. You can now
configure other advance sections or start using the router (with the advance settings in place)
that you wish to setup an Access Control rule. You can
select a range of users simply by inputting the starting
users' last digit (octet) IP address and the last user's last
octet IP address in the appropriate boxes. If you want to
select only one user then input the user's last digit IP
address in both boxes.
Note: You need to give your LAN PC clients a
fixed/static IP address for the Access Control rule to
work properly.
You can block the clients from accessing some
Internet services by checking the services you want
to block.
This allows you to select UDP or TCP protocol type
you want to block.
You can assign up to five port ranges. The router
will block clients from accessing Internet services
that use these ports.
You can select one of the Scheduling Rule you set
previously and the router will block the clients
during the time in the Scheduling Rule.
55