Table of Contents
Advertisement
Replacing the Lamp unit
J
CAUTION:
When the projector is mounted on a ceiling, do not work with your face close to the projector.
z
Attach the lamp unit and the lamp cover securely.
z
When you experience difficulty in installing the lamp, remove it and try again. If you use force to install the
z
lamp, the connector may be damaged.
1 )
Turn off the Power by following the procedure
in "Turning off the projector (
Unplug the AC power cord. Wait at least
45 minutes and make sure the lamp unit and
surroundings are cool.
2 )
Use a Phillips screwdriver to loosen the
lamp cover fixing screw and open the
lamp cover.
Open the lamp cover by pulling it slowly toward
z
the direction of the arrow.
3 )
Use a Phillips screwdriver to loosen the
three lamp unit fixing screws until the
screws turn freely. Hold the used lamp
unit by its handles, and pull it gently
from the projector.
4 )
Insert the new lamp unit in correct direction.
Tighten the three lamp unit fixing screws
securely with a Phillips screwdriver.
5 )
Close the lamp cover, and tighten the
lamp cover fixing screw securely with
a Phillips screwdriver.
Close the lamp cover by pushing it slowly opposite
z
the direction of the arrow.
Note
When you replace the new lamp unit (ET-LAV100), the projector resets the total usage time of the
z
lamp unit automatically.
page 27)".
Æ
Replacement
Lamp cover
Lamp cover
fixing screw
Lamp unit fixing screws
Lamp unit
Handles
Lamp unit
ENGLISH -
75
Advertisement
Table of Contents
