Status Information; Operating The Drive - ABB ACS550-01 User Manual

ACS550 User's Manual

Status Information

Top. The top line of the LCD display shows the basic status information of the drive.
• LOC – indicates that the drive control is local, that is, from the control panel.
• REM – indicates that the drive control is remote, such as the basic I/O (X1) or
fieldbus.
•
Rotating arrow (clockwise or counter
clockwise)
Rotating dotted blinking arrow
Stationary dotted arrow
• Upper right – shows the active reference.
Middle. Using parameter Group 34, the middle of the LCD display can be configured
to display:
• Up to three parameter values.
– By default, the display shows three parameters.
– Use parameters 3401, 3408, and 3415 to select the parameters (from Group
– You can also scale each parameter in the display, for example, to convert the
• A bar graph rather than any of the parameter values.
– Enable bar graph displays using parameters
Bottom. The bottom of the LCD display shows:
• Lower corners – show the functions currently
assigned to the two soft keys.
• Lower middle – displays the current time (if configured to show the time).

Operating the Drive

LOC/REM – The very first time the drive is powered up, it is in the remote control
(REM) mode, and is controlled from the Control Terminal Block X1.
– indicates the drive and motor rotation status as follows:
Control Panel Display
The particular parameters depend on the value of
parameter 9904
MOTOR CTRL MODE
if 9904 = 1, the display shows parameters 0102
( ), 0104 (
SPEED CURRENT
01) to display. Entering "parameter" 0100 results in no parameter displayed.
For example, if 3401 = 0100 and 3415 = 0100, then only the parameter
specified by 3408 appears in the Control Panel display.
motor speed to a display of conveyor speed. Parameters 3402...3405 scale
the parameter specified by 3401, parameters 3409...3412 scale the parameter
specified by 3408, etc.
3404, 3411 and 3418.
• Drive is running and at setpoint
• Shaft direction is forward
Drive is running but not at setpoint.
Start command is present, but motor is not
running. E.g. start enable is missing.
. For example,
), 0105 ( ).
TORQUE
Significance
or reverse
Start-Up
29