Safety Instructions And Warnings - NETGEAR XS728T Hardware Installation Manual

ProSAFE 28-Port and 48-Port 10-Gigabit Smart Managed Switch Models XS728T and XS748T
• NETGEAR green power-saving features:
- Energy efficiency mode that fully conforms to the IEEE 802.3az standard.
- Per-port automatic change to a lower power mode when the port link is down.

Safety Instructions and Warnings

Use the following safety guidelines to ensure your own personal safety and to help protect
your system from potential damage.
To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment,
observe the following precautions:
• This product is designed for indoor use only in a temperature-controlled (0–50°C) and
humidity-controlled (10–90 percent relative humidity) environment.
Any device that is located outdoors and connected to this product must be properly
grounded and surge protected.
To the extend permissible by applicable law, failure to follow these guidelines could result
in damage to your NETGEAR product, which may not be covered by NETGEAR's
warranty.
• Observe and follow service markings:
- Do not service any product except as explained in your system documentation.
- Opening or removing covers that are marked with the triangular symbol with a
lightning bolt can expose you to electrical shock. We recommend that only a trained
technician services components inside these compartments.
• If any of the following conditions occur, unplug the product from the electrical outlet and
replace the part or contact your trained service provider:
- The power cable, extension cable, or plug is damaged.
- An object fell into the product.
- The product was exposed to water.
- The product was dropped or damaged.
- The product does not operate correctly when you follow the operating instructions.
• Keep your system away from radiators and heat sources. Also, do not block cooling
vents.
• Do not spill food or liquids on your system components, and never operate the product in
a wet environment.
• Do not push any objects into the openings of your system. Doing so can cause fire or
electric shock by shorting out interior components.
• Use the product only with approved equipment.
• Allow the product to cool before removing covers or touching internal components.
Introduction
8