ULN Res. D Series
Inner Door Removal Procedure
Step 1.
Position gas control power switch to the
"OFF" position.
Step 2.
Remove outer jacket burner access door.
Step 3.
Remove (2) ¼" hex drive screws from right side inner door.
Step 4.
Remove (2) ¼" drive screws from flange section of inner door.
Step 5.
Remove (3) ¼" drive screws from left side inner door.
Step 6.
Remove inner door and inspect per step 7.
Step 7.
Fully inspect inner door gaskets for the
following:
-Tears
-Missing Material -Gasket adhesion to inner door
-Cracks
-Dirt or debris
If the gasket is not affected by any of the above, gasket replacement is not required. If
replacement is required, proceed to Inner Door Gasket Replacement Procedure.
Inner Door Gasket Replacement Procedure
If the information in these instructions is not followed exactly, a
fire or explosion may result causing property damage, personal
Step 8.
After inspection of inner door as noted in step 7, completely remove gasket and
adhesive residue from right and left side inner doors as needed.
-Other imperfections that will inhibit proper seal
-Material left on combustion chamber (around opening)
injury or death.
WARNING
27
27