Bosch WFL 2090 Operating, Care And Installation Instructions Manual page 32

Connection options
A Cold water connection and
B Hot water connection (max.140°F/60 °C)
Water drainage
Do not bend or pull the water drainage hose.
Height difference betweenthe placement area
of washer and the drainage point:
Maximum110 cm
/ 43 inches.
Standpipe or In Wall Installation
or Cold water connection only with Y-piece
I_ Use the U-bracket. Attach the U-bracket to the
end of the hose and insert end of hose into
standpipe or wall drain.
Use a strap or cable tie connected to U-bracket
to hold hose in place.
Drainage into a siphon
_3 After the connection:
Turn on the water completely, and check
whether connection points are watertight.
The connection points are under full water
pressure. Check seal with tap fully open.
Secure the connection point with a hose
clamp.
32