Technical Data; Installation - Zanussi ZQF11430DA User Manual

Problem
There is too much frost.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".

Technical data

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.

Installation

Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated in-
door (garage or cellar) also, but for optimum performance
install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
Possible cause
The product temperature is too high.
Many products are stored at the same
time.
Products are too near to each other.
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not set
correctly.
Height
Width
Depth
Let the product temperature decrease to
room temperature before storage.
Store less products at the same time.
Store products so that there is cold air
circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
815 mm
560 mm
550 mm
29 h
230-240 V
50 Hz
Climate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Solution
Ambient temperature
17