Page 3
Make sure that the power plug is not squashed or • Do not clean the appliance with metal objects. damaged by the back of the appliance. A squash- • Do not use sharp objects to remove frost from the ap- ed or damaged power plug may overheat and pliance.
Control panel Pilot light • turn the Temperature regulator toward higher settings to obtain the maximum coldness. Temperature regulator A medium setting is generally the most suitable. Fast Freeze light Fast Freeze switch However, the exact setting should be chosen keeping in Acoustic alarm reset switch mind that the temperature inside the appliance depends Alarm light...
First use Cleaning the interior Important! Do not use detergents or abrasive powders, as these will damage the finish. Before using the appliance for the first time, wash the inte- rior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly.
• make sure that the commercially frozen foodstuffs were • Once defrosted, food deteriorates rapidly and cannot be adequately stored by the retailer; refrozen. • be sure that frozen foodstuffs are transferred from the • Do not exceed the storage period indicated by the food foodstore to the freezer in the shortest possible time;...
leave the door/doors open to prevent unpleasant Important! If the cabinet will be kept on, ask somebody to smells. check it once in a while to prevent the food inside from spoiling in case of a power failure. What to do if… Warning! Before troubleshooting, disconnect the Important! There are some sounds during normal use mains plug from the mains socket.
Problem Possible cause Solution The product temperature is too high. Let the product temperature decrease to room temperature before storage. Many products are stored at the same Store less products at the same time. time. Products are too near to each other. Store products so that there is cold air circulation.
Ventilation requirements Important! The wires in the mains lead are coloured in accordance with the following code: The airflow behind the ap- 5 cm pliance must be sufficient. min. 200cm Green and Yellow: Earth C Brown: Live min. D Blue: Neutral 200cm As the colours of the wires in the mains lead of this appli-...