Page 2
EN 50 144, Direction de recherce et développement EN 55 014, EN 61 000 direktiivien 73/23/EY, 98/37/EY, 89/336/EY määräysten mukaan. Festool GmbH Wertstr. 20 D-73240 Wendlingen EF-konformitetserklæring: Vi erklærer at have alene Dr. Johannes Steimel ansvaret for, at dette produkt er i overensstemmelse med de følgende normer eller normative dokumenter:...
Page 4
Electrical connection and start-up Working with the RAP 80.02 E The mains voltage must correspond The RAP 80.02 E is a compact, handy tool for with the voltage figure on the polishing painted or varnished surfaces. ratings plate! It can also be used for sanding work if fitted Push the sliding switch (1.1) forwards to switch...
Page 5
tighten square-head threaded bolt (4.3) by Connect the hose (Ø 27 mm) of a hand, Festool dust extractor to the adapter replace clamping lever and fasten with screw. (3.2) on the rear of the rotary The optimum position can be determined by polishers casing.
Page 6
We reserve the right to make changes to the The accessory order number can be found in technical data contained in this information as your Festool catalogue or on the Internet under a result of ongoing research and development www.festool.com".
Need help?
Do you have a question about the Rap 80.02 E and is the answer not in the manual?
Questions and answers