Betec ZB-10 Instruction Manual page 10

If the unit is on ice making,indicator
reservoir,but please take out the ice first, then add one full cup of water so as to avoid overflow of water
when the ice melt.
Step 3
Press ON/OFF button to start the machine.
Step 4
Water will be pumped into the water tray from the water reservoir automatically,this takes about 30
seconds
Note: If no water is pumped to the water tray over two cycles but the water in reservoir is enough, then
please open the drain cap, and let several drops water runs out. Then press ON/OFF button
again to restart the unit
Step 5
Select the button S/SMALL,M,L/LARGE to choose the ice size you may need
Note: when temperature lower than 15degrees,S/SMALL is recommended,when temperature over
30degrees,L/LARGE ice is recommended.
Step 6
Ice making cycle begins,ice will be frozen onto the evaporator fingers.
Note: the ice making time depends on the ambient temperature
Step 7
Once ice making cycle is finished,the water tray will tilt forward; the remaining water flows back to the
water reservoir and the ice cubes will drop from the fingers.
Step 8
In about 15-35 seconds, the water tray will tilt backward,ice in produced in previous cycle will be pushed
to ice reservoir directly,unit back to work from step 4 to step 6 again
Step 9
Push the ice cube dispenser puncher button(sketch 6) to get ice, the indicator
Note: Please put your cup below the ice cube dispenser shoot directly.
Notice: If the ice is stored in the unit for long time,the ice may freeze and stick together,then no ice will be
dispensed even the ice is full,if so,please kindly use scoop included in the unit to break the ice
first,then push the puncher button.
Step 10
Press ON/OFF button to stop the unit
Step 11( for ZB-10B only)
When you push the WATER button, you can get water
Note: if you need to get cold water,at least the ice making function should be turn on.
Please make sure your cup is below the cold water outlet,or water will be splashed every where
Caring
1.Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently. When
cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to
clean the inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or
diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.
is on,but want to make more ice,then add water to the water
will be on