Figure 31
1. Rear pressure on the service-brake lever
3. Loosen the retainer securing the V-belt cover and pivot
the cover open (Figure 32).
1
Figure 32
1. V–belt cover
4. To adjust the brake cable tension, proceed as follows.
•
To decrease the cable tension, loosen the front
cable jam nut and tighten the rear jam nut (Figure
33). Repeat steps 1 and 2 and readjust if required.
•
To increase the cable tension, tighten the front
cable jam nut and loosen the rear jam nut (Figure
33). Repeat steps 1 and 2 and readjust if required.
Note: The adjustment can be performed on the
cable at the jam nut brackets by the control panel
or at the bracket at the base of the engine.
2
G016991
2. Retainer
1. Service/parking brake
cable
5. Close the cover and secure the retainer.
28
Figure 33
2. Front jam nut