Storage; Cleaning And Storage - Toro 74978 Operator's Manual

Storage

Cleaning and Storage

Storage areas should be equipped with at least one approved
portable fire extinguisher having a minimum capacity of 18 lb
(8.2 kg) dry chemical with a B:C rating. Do Not use Carbon
Tetrachloride extinguishers (Pyrene etc.).
1. Disengage the power take off (blade control switch
(PTO), set the parking brake, and turn the ignition key
to Off. Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine and hydraulic system. Clean dirt and chaff from
the outside of the engine cylinder head fins and blower
housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, engine, hydraulic pumps,
and motors.
3. Check the brake; refer to Servicing the Brake in the
Maintenance Section.
4. Service the air cleaner; refer to Servicing the Air
Cleaner in the Maintenance Section.
5. Grease the machine; refer to Greasing and Lubrication
in the Maintenance Section.
6. Change the crankcase oil; refer to Servicing the Engine
Oil in the Maintenance Section.
7. Check the tire pressure; refer to Checking the Tire
Pressure in the Maintenance Section.
8. Change the hydraulic filters; refer to Servicing the
Hydraulic System in the Maintenance Section.
9. Charge the battery; refer to Servicing the Battery in
the Maintenance Section.
10. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
Note: Run the machine with the blade control switch
(PTO) engaged and the engine at high idle for 2 to
5 minutes after washing.
11. Check the condition of the blades; refer to Servicing
the Cutting Blades in the Maintenance Section.
12. Prepare the machine for storage when non-use occurs
over 30 days. Restart the engine and run it until it stops.
13. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
14. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
15. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it
out of reach of children or other unauthorized users.
Cover the machine to protect it and keep it clean.
62