Toro 74978 Operator's Manual page 46

match after the shim is removed to ensure proper
brake torque.
Figure 66
1. Brake mounting bolt
B. Using needle nose pliers, or by hand, take hold
of the tab and remove the shim (Do Not discard
the shim until proper clutch function has been
confirmed).
Figure 67
1. Shim
C. Using a pneumatic line, blow out any debris
from under the brake pole and around the brake
spacers.
D. Re-torque each bolt (M6 x 1) to 10 ft-lb (13 N-m)
+/-0.5 ft-lb (0.7 N-m).
E. Using a 0.010 inch thick feeler gauge, verify that
a gap is present between the rotor and armature
face on both sides of the brake pole as shown.
(Due to the way the rotor and armature faces
wear (peaks and valleys) it is sometimes difficult
to measure the true gap.)
1. Feeler gauge
1. Feeler gauge
•
If the gap is less than 0.010 inch, then reinstall
the shim and reference the Troubleshooting
section.
•
If the gap is sufficient, proceed to the safety
check in step F.
F. Perform the following safety check:
i. Sit on the seat and start the engine.
ii. Make sure the blades Do Not engage
with the PTO switch "off " and the clutch
disengaged.
If the clutch does not disengage,
reinstall the shim and reference the
Troubleshooting section.
iii. Engage and disengage the PTO switch
ten consecutive times to ensure the clutch
is functioning properly. If the clutch
does not engage properly, reference the
Troubleshooting section.
46
Figure 68
Figure 69