Toro 07200 Operator's Manual page 15

4. Install the reserve tank cap.
CHECK THE TRANSAXLE /
HYDRAULIC FLUID
The transaxle reservoir is filled with Dexron II ATF.
Check the level before the engine is first started and
every 8 hours or daily, thereafter. Capacity of the
system is 7.1 l (7.5 qt).
1. Position the vehicle on a level surface.
2. Clean the area around the dipstick.
3. Unscrew the dipstick from the top of the
transaxle and wipe it with a clean cloth.
Figure 7
1. Dipstick
4. Screw the dipstick into the transaxle and make
sure it is seated fully. Unscrew the dipstick and
check fluid level. Fluid should be up to the top of
flat portion of the dipstick. If the level is low,
add enough fluid to achieve the proper level.
CHECK FRONT DIFFERENTIAL
OIL
Four-Wheel Drive Model Only
The differential is filled with 10W30 oil. Check the
level of oil every 100 hours or monthly. Capacity of
the system is 0.95 l.
1. Front differential
2. Fill plug
3. Drain plug
1. Position the vehicle on a level surface.
2. Clean the area around the fill plug on the side of
the differential
3. Remove the fill plug and check the level of oil.
Oil should be up to the hole. If it is low, add
10W30 oil.
4. Install the fill plug.
CHECK WHEEL NUT TORQUE
WARNING
Failure to maintain proper torque could result in
failure or loss of wheel and may result in personal
injury. Torque front and rear wheel nuts to 61–88
Nm after 1–4 hours of operation and again after 10
hours of operation and every 200 hours thereafter.
CHECK BRAKE FLUID
The brake fluid reservoir is shipped from the factory
filled with brake fluid. Check the level before the
engine is first started and every 8 hours or daily,
thereafter.
1. Park the machine on a level surface.
2. Fluid level should be up to the FULL line on
reservoir.
Before Operating
Figure 8
15