Cleaning - Proficook PC-EKI 1034 Instruction Manual

2. Press the TIMER button. The display shows
"0". The indicator light next to the display will
light up.
3. Set a turn-off time between 1 and 180 minutes
by using the or the
NOTE:
• Briefly press the
the time in increments of one minute. The
display will show the desired setting.
• Once you have set a time, the display will
remain for a few seconds. Then the func-
tion that you had selected previously will
be shown again.
• If you would like to verify the turn-off time,
press the TIMER one more time. The dis-
play will show the remaining running time
for a few seconds.
• You may change the previous turn-off time
at any time. The other settings (HEAT and
TEMP.) will remain.
• After the set time has elapsed, the cooking
time will automatically be turned off and a
beep will sound. The appliance is in stand-
by mode again.
• To cancel the turn-off time early, set the
TIMER to less than "1". The cooking plate
will turn off and will switch back to standby
mode. You may also turn the appliance off
directly with the ON/STANDBY button.
Automatic shut-off
The hot plate turns off automatically after
120 minutes, if no input was given over the opera-
tor control panel during this time. This switching
serves as security for you.
Switching off
1. Press the ON/STANDBY button (9).
NOTE:
• The hot plate is reset from its operational
state to standby mode. The fan may con-
tinue to run for a period of time.
52
button.
or the button to set
NOTE:
• The indicator lights next to the display will
go out.
• The display shows the message "– H –"
for "Hot" as long as the temperature of the
cooking surface is higher than 50°C.
• The display shows the message "– L –",
when the temperature of the cooking
surface is lower than 50°C.
2. Pull the plug.
3. Let the device cool down, before you put it
away.
Pan recognition
The device has a pot recognition function. It gives
several warnings to indicate that the cookware has
been removed. The message "– – –" appears on
the display. For safety reasons, the appliance will
switch to standby mode after about 15 seconds.
The fan may continue running.
In this context, please pay attention to the follow-
ing:
WARNING:
After use, the hot plate is to be switched off by
means of its regulation and control devices [ON/
STANDBY button (9)] and not just by pan recog-
nition.
WARNING: Hazard of burns!
Because of the heat radiated during cooking,
dangerously high temperatures may occur at the
cooking zone after the cooking cycle.

Cleaning

WARNING:
• Always remove the mains lead before clean-
ing!
• Wait until the machine has cooled down
completely!