Checking The Engine Oil Level; Cleaning The Underside Of The Lawn Mower Housing - Toro Super Recycler 20781 Operator's Manual

Checking the Engine Oil Level

Before you use the lawn mower, ensure that the oil level is
between the Add and the Full marks as shown on the
dipstick (Fig. 7). If the oil level is below the Add mark, add
oil. Refer to Filling the Crankcase with Oil on page 8.
Cleaning the Underside of the
Lawn Mower Housing
Keep the underside of the lawn mower housing clean. Be
especially careful to keep the kickers free of debris
(Fig. 16).
Figure 16
1. Kicker plates
Washing Method
1. Move the lawn mower onto a flat paved surface near a
water hose.
2. Remove the grass bag.
3. Attach a quick-disconnect coupling (sold separately) to
the end of the water hose.
4. Attach the coupling to the lawn mower washout fitting
(Fig. 17).
1. Washout fitting
5. Turn the water on high.
6. Start the engine.
7. Let the lawn mower run for 2 minutes.
8. Stop the engine and wait for all moving parts to stop.
9. Turn the water off.
979
10. Remove the coupling from the washout fitting.
11. Move the lawn mower to a dry area, and let the engine
run for one minute to dry out the lawn mower and its
components.
12. Stop the engine and wait for all moving parts to stop.
If the underside of the lawn mower deck has excessive
grass buildup, wait 30 minutes and repeat steps 3 through
12 above.
A broken or missing washout fitting could expose
you and others to thrown objects or to the blade,
causing injury or death.
Replace a broken or missing washout fitting
immediately before using the lawn mower again.
Plug any hole(s) in the lawn mower with bolts
and locknuts.
Never put your hands or feet under the lawn
mower or through openings in the lawn mower.
15
2
1
Figure 17
2. Hose
Warning
m-3044