Table of Contents
Advertisement
5. Slide the upper handle section ends over the lower
handle so the sections nest together (Fig. 3).
1
4
Figure 3
1. Knobs
2. Contoured-handle bolt (2)
3. Upper handle
6. Ensure that the cables are routed below and behind the
lower handle as illustrated in Figure 3.
7. Secure the upper handle to the lower handle using 2
contoured-handle bolts and 2 knobs (Fig. 3).
Installing the Starter Rope
Pull the starter rope through the rope guide on the handle
(Fig. 4).
Figure 4
1. Rope guide
2
3
5
m-4204
4. Lower handle
5. Cables
210
2. Starter rope
Installing the Discharge Tunnel
Plug
1. Stop the engine and wait for all moving parts to stop.
2. Open the discharge door by moving it rearward (Fig. 5).
Figure 5
1. Discharge door handle
3. Hold the discharge door handle to prevent the
spring-loaded door from closing while you insert the
discharge tunnel plug.
4. Rotate the plug clockwise slightly while inserting it
(Fig. 5).
Note: Ensure that the arrow on the plug decal points
upward.
5. Push the plug all the way in until the spring clip on the
bottom of the plug clicks into place (Fig. 6).
Figure 6
1. Spring clip
6. Release the discharge door handle to lock the top of the
plug.
7
1914
2. Discharge tunnel plug
1915
Advertisement
Table of Contents
