Toro 30881 Operator's Manual page 19

Protected Menus
There are 5 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter: auto
idle, maximum mowing ground speed, maximum transport
ground speed, Smart Power, and deck counter balance. These
settings are in the Protected Menu.
Accessing the Protected Menu Settings
1. From the Main Menu, scroll down to the Settings
Menu and press the right button.
2. In the Settings Menu, scroll down to the Protected
Menu and press the right button.
3. To enter the passcode, use the center button to set
the first digit then press the right button to move on
to the next digit.
4. Use the center button to set the second digit then press
the right button to move on to the next digit.
5. Use the center button to set the third digit then press
the right button to move on to the next digit.
6. Use the center button to set the fourth digit then press
the right button.
7. Press the middle button to enter the code.
The ability to view and change the settings in the Protected
Menu can be changed. Once the Protected Menu has been
accessed, scroll down to Protect Settings. Using the right
button, changing Protect Settings to O
ability to view and change the settings in the Protected Menu
without entering the passcode. Changing Protect Settings to
O will hide the protected options and will require entering a
N
passcode to change the setting in the Protected Menu. After
the passcode has been set, the key switch must be turned off
and back on to enable and save this feature.
Viewing and Changing the Protected Menu Settings
1. In the Protected Menu, scroll down to Protect Settings.
2. To view and change the settings without entering a
passcode, use the right button to change the Protect
Settings to O .
FF
3. To view and change the settings with a passcode, use
the left button to select O
the key in the ignition switch to the O
then to the O position.
N
Setting the Auto Idle
1. In the Settings Menu, scroll down to Auto Idle.
2. Press the right button to change the auto-idle time
between O , 8S, 10S, 15S, 20S, and 30S.
FF
Setting the Maximum Allowed Mow Speed
1. In the Settings Menu, scroll down to Mow Speed and
press the right button.
will allow the
FF
, set the passcode, and turn
N
position and
FF
2. Use the right button to increase the max full mow
speed (50%, 75%, or 100%).
3. Use the center button to decrease the max full mow
speed (50%, 75%, or 100%).
4. Press the left button to exit.
Setting the Maximum Allowed Transport Speed
1. In the Settings Menu, scroll down to Transport Speed
and press the right button.
2. Use the right button to increase the max transport
speed (50%, 75%, or 100%).
3. Use the center button to decrease the max transport
speed (50%, 75%, or 100%).
4. Press the left button to exit.
Turning the Smart Power ON/OFF
1. In the settings menu, scroll down to Smart Power.
2. Press the right button to switch between O
3. Press the left button to exit.
Setting the Counterbalance
1. In the Settings Menu, scroll down to Counter Balance
and press the right button.
2. Press the right button to switch between Low, Med,
and High.
When finished with the Protected Menu, press the left button
to exit to the Main Menu, then press the left button to exit
to the Run Menu.
Stationary Regeneration
If the Stationary Regeneration icon appears on the InfoCenter,
refer to the Service Manual or contact your Toro Distributor
for the maintenance procedure.
DPF Ash Level
The DPF ash level may be checked by entering the PIN as
described in Accessing the Protected Menu Settings (page 19)
and navigating to the service section.
19
and O .
N FF