Engine Maintenance; General Air Cleaner Maintenance Practices; Servicing Air Cleaner; Changing Engine Oil And Filter - Toro 07360 Operator's Manual

Engine Maintenance

General Air Cleaner
Maintenance Practices
Service Interval: Every 50 hours
Every 200 hours
• Inspect air cleaner and hoses periodically to maintain
maximum engine protection and to ensure maximum
service life.
• Check air cleaner body for damage which could
possibly cause an air leak. Replace a damaged air
cleaner body.
• Clean the air cleaner filter every 50 hours and change
every 200 hours (more frequently in extreme dusty
or dirty conditions).

Servicing Air Cleaner

1. Pull latch outward and rotate air cleaner cover
counter–clockwise.
Figure 47
1. Air cleaner cover
2. Before removing the filter, use low pressure
air (40 psi, clean and dry) to help remove large
accumulations of debris packed between the outside
of the primary filter and the canister.
Important: Avoid using high pressure air which
could force dirt through the filter into the intake
tract. This cleaning process prevents debris
from migrating into the intake when the primary
filter is removed.
3. Remove and replace the primary filter.
2. Filter
Note: Cleaning of the used element is not
recommended due to the possibility of damage to
the filter media.
4. Inspect the new filter for shipping damage, checking
the sealing end of the filter and the body.
Important: Do not use a damaged element.
5. Insert the new filter by applying pressure to the outer
rim of the element to seat it in the canister.
6. Clean the dirt ejection port located in the removable
cover. Remove the rubber outlet valve from the
cover, clean the cavity, and replace the outlet valve.
7. Install the cover orienting the rubber outlet valve in
a downward position–between approximately 5:00 to
7:00 when viewed from the end.
8. Secure the cover latches. Reset the indicator if it is
showing red, if so equipped.

Changing Engine Oil And Filter

Service Interval: After the first 50 hours
Every 150 hours
1. Raise bed (if so equipped) and place safety support
on extended lift cylinder to hold up bed.
2. Remove drain plug and let oil flow into drain pan.
When oil stops, install drain plug.
1. Engine oil drain plug
3. Remove oil filter. Apply a light coat of clean oil to
the new filter seal before screwing it on. Screw filter
on until gasket contacts mounting plate, then tighten
1/2 to 2/3 of a turn. DO NOT OVER–TIGHTEN.
41
Figure 48