Care And Cleaning; Range Hood; Filters - Westinghouse QR043 Owner's Manual

Care and Cleaning

RANGE HOOD

WARNING:
Failure to maintain basic standards of care and cleaning of the range hood will increase the risk of fire.
The range hood should be cleaned (regularly internally and externally) to preserve its appearance and performance .
Do:
- Always clean in the direction of the grain (original
polish lines) .
- Clean the range hood periodically with hot, soapy
water and a clean cotton cloth .
- Always rinse well with clean water two or three
times after cleaning . Wipe completely dry with a
soft non-abrasive cloth.
- After cleaning, you may polish with a non-abrasive
stainless steel polish or cleaner . Always rub lightly
and with the grain .
- Ensure that the venting system is free of debris, if
you have one .

FILTERS

The filter fitted by the factory is intended to filter out residue and grease from cooking. You do not need to replace them on a regular basis,
but you should keep them clean .
Do:
- Clean the filters once a month using non-abrasive
detergents, either by hand or in the dishwasher .
When using a dishwasher, set the dishwasher to
a low temperature and a short cycle setting . The
filter may become discoloured in a dishwasher, but
this does not affect its performance .
- Dry the filters before re-installing them in the range
hood .
Do Not:
- Do not use corrosive or abrasive detergents, steel
- Do not use corrosive or abrasive detergents, or any
- Do not allow cleaning compounds, salt solutions,
- Do not allow deposits to remain for long periods
- Do not let plaster dust or any other construction
- Combustible products used for cleaning such as
Do Not:
- Do not allow oil to accumulate over more than 80%
- Do not wash charcoal filters. Charcoal filters should
15
Please contact customer.service@conglomkb.com or 1-877-333-0098 for further assistance.
wool, or scouring pads . These will scratch and
damage the stainless steel surface .
products containing chloride, fluoride, iodide, or
bromide on this product, as they will deteriorate
the surface rapidly .
disinfectants, or bleaches to remain in contact with
the product for extended periods of time .
of time on the range hood . Rinse with water
immediately and wipe dry with a clean cloth .
residue enter the hood . During construction or
renovation, cover the hood .
acetone, alcohol, ether, or benzol are highly explosive
and should never be used close to a range or stove .
of the filter surface. Oil accumulations may drip oil
onto the range .
be replaced when they are covered in grease and
have reached their maximum absorbancy .
CONGLOMKB .COM