Usb Storage Information Registration - Sanyo VPC-C4EX Service Manual

4. USB STORAGE INFORMATION
REGISTRATION
USB storage data is important for when the camera is con-
nected to a computer via a USB connection.
If there are any errors in the USB storage data, or if it has not
been saved, the USB specification conditions will not be sat-
isfied, so always check and save the USB storage data.
Preparation:
POWER switch: ON
Adjustment method:
1. Connect the camera to a computer. (Refer to 3-5. Con-
necting the camera to the computer on the page 15.)
2. Double-click on the DscCalDi.exe.
3. Click on the Get button in the USB storage window and
check the USB storage data.
VID: SANYO
PID: C4
Serial:
Rev. : 1.00
4. Check the "Serial" in the above USB storage data. If the
displayed value is different from the serial number printed
on the base of the camera, enter the number on the base
of the camera. Then click the Set button.
5. Next, check VID, PID and Rev. entries in the USB storage
data. If any of them are different from the values in 3. above,
make the changes and then click the corresponding Set
button.
Calibration Upload LCD
RGB Odd
AWB
Firmware
Focus
RGB Gain
Image
UV Matrix
Tint
Cal Mode
Initialize
OK
VCO
EVF
H AFC
Cal Data
LCD Type
OK
USB storage
VID
Get Set Serial
Set PID
RGB Even
VCOMPP(LOW)
VCOMDC VCOMPP(HI)
Phase
Hall Cal.
Test
Setting
Language
Set
Video Mode
Set Rev. Set
Factory Code
– 20 –