Table of Contents
Advertisement
User's Manual
Printing is out of Alignment
•
When the printing is going beyond the page length, please verify the page size settings
of the printer output software.
•
When the printing is not off by a full line but is slipping just a little bit, it may be a
failure in the paper roller due to wear. Please contact the sales agent.
Ink Printing is Too Light
•
Please change the ink ribbon cassette.
Wrinkles between the Braille Dots
•
If you are doing your printing in places which are high in humidity, wrinkles between
the Braille dots may occur. Please try printing on a day where the weather is good or
in a dry location or try using the low speed print mode.
Stops during Printing
•
If the PC is configured for usage of a screen saver or system standby, or to cut the power
to the hard drive, there are cases where it may not be possible to print a long document.
If you are printing long documents, please configure the PC so that the power
management always keeps the power on.
•
If there is a paper jam, turn off the power. When you reboot the printer, the paper lock
will be released as part of the initialization sequence. Afterwards, turn the power back
on again and eject the clogged paper by using the Paper Cutter Handle.
•
If communications are through the RS-232C interface, please verify that the settings on
the host side are configured for "Using Flow Control".
© Nippon Telesoft Co., Ltd. March 2003.
17
Advertisement
Table of Contents
