Table of Contents
Advertisement
User's Manual
Printing Will Not Start (Unable to Receive Data)
•
Check that there is paper loaded into the feeder.
•
Verify that the cable being used is firmly connected at both the printer and the PC.
If you changed the switch settings, verify that the switches are correct. Additionally, try
restoring the switch settings to what they were just before printing was last done
successfully.
•
If you are using an RS-232C cable, please verify that the installed software and printer
driver are properly configured for RS-232C cable output.
Also please verify that the communications settings and the communications
o
speed on the printer Settings Panel match the communications settings and speed
of the software and printer driver.
Furthermore, there are some personal computers that have several RS-232C ports.
o
Please verify that the port that you are using matches the settings within the
software and printer driver that you are using.
•
If you are using a printer (parallel port) cable, please verify whether the configuration
settings of the software and printer driver you are using are correct for printer cable
output.
•
When error sound rings at receiving the data, confirm whether the switch of the control
panel is set correctly. Especially, check if the software to support and the switch for
format matches correctly or not, and also, when RS-232C communication check if it is
set to do flow control by confirming the switch and setup of software at the personal
computer's side.
Not Printing the Data Properly
•
If the Braille or ink characters of some rows are scrambled, or are missing dots, or have
excess dots here and there, please perform a test print. Refer to "Chapter 6 Section 1.
Printing" (Page 13) for instructions. If excess or missing dots are also occurring on the
printer test page, please contact the sales agent.
•
Verify the settings of the printer output software and the printer name.
© Nippon Telesoft Co., Ltd. March 2003.
16
Advertisement
Table of Contents
