Table of Contents
Advertisement
User's Manual
1. Printing Procedures
Connecting the data input connector
Connect the communications cable to the RS-232C, parallel or USB connector.
(It is impossible to use USB but for the upgraded version after Windows 2000 only.)
【
Caution
】
the power to the printer unit as well as other peripherals.
Turning on the power switch
First turn on power at the host side (personal computer, etc.). Then turn on the printer
power.
When turning power off, first the printer, then the personal computer.
Loading paper
Load the paper into the feeder.
Data input
Input some data from the host (personal computer, etc.) side. Please consult the respective
manuals for installation and operational procedures of each software program on the host
computer.
Printer mode, character codes, and so forth are configured within the host printer software.
It is also possible to schedule multiple print jobs in succession.
Initiating Printing
Printing will start as soon as data is input.
Note: When the paper is about to run out, the last sheet will stop at the roller before the
cutting position. The Out of Paper Lamp will come on and the buzzer will sound. Pull
out the paper a little.
Load the new paper into the feeder and press the Load Paper Switch. Continuation of
the printing will then begin.
Chapter 5 – Methods of Operation
:When inserting or removing the communications cable, always first turn off
© Nippon Telesoft Co., Ltd. March 2003.
11
Advertisement
Table of Contents
