Table of Contents
Advertisement
Before connecting
• Refer also to the instruction manual of each component to be
connected.
• When you connect the DVD Changer Receiver to audio/video
equipment, be sure to turn off the power and unplug all the units
from the mains before making any connections.
L
A
R
FRONT
SPEAKERS
L
B
R
L
SURROUND
SPEAKERS
R
CENTER
SPEAKER
I Turning the unit on/off with the TV's power switch — IPM function
The DVD Changer Receiver is equipped with the Intelligent
Power Management (IPM) system. Just turn on your TV's
power switch and, in about 5 seconds, the DVD Changer
Receiver turns on automatically. If you turn off the TV's power
switch, IPM indicator flashes on the display and the DVD
Changer Receiver automatically turns off in about 5 minutes.
MD Recorder, Cassette Tape
Deck, CD Recorder , Hard Disk
TV
AUDIO
AUDIO
OUT
OUT
R
L
R
L
TV/LINE
TAPE/CD-R
IN
IN
OUT
L
AUDIO
R
DO NOT connect the
power cord at this time.
• Connect the plugs securely.
Recorder etc.
DIGITAL
AUDIO
IN
IN
OPTICAL
R
L
L
R
ANTENNA
ANTENNA
VIDEO 2
VIDEO 1
IN
IN
OUT
SUB
DIGITAL IN
DIGITAL
WOOFER
OUT
VIDEO 2
VIDEO 1
VIDEO
S VIDEO
PRE OUT
COAXIAL
OPTICAL
OPTICAL
To activate the IPM function
1 Connect the audio output of your TV's audio output to the
DVD Changer Receiver's TV/LINE IN L/R jacks (refer to page
15).
2 Press MODE RCVR/VCR on the remote controller.
3 Press IPM on the remote controller repeatedly until "IPM ON"
appears on the display. The IPM indicator illuminates in the
display.
Notes
• The IPM system may not function properly with some TV sets.
• When using monaural TV, connect the audio output of the TV to
the DVD Changer Receiver's TV/LINE IN L jack.
• When the TV is turned off while the DVD Changer Receiver
selects other input source, the DVD Changer Receiver does not
turn off.
Incomplete
Insert completely
Audio cable
Optical fiber cable
Signal flow
COMPONENT VIDEO
P
R
VIDEO 2
VIDEO 1
MONI
OUT
IN
IN
OUT
P
B
Y
IN
OUT
19
Hide quick links:
Advertisement
Table of Contents
