Safety And Instruction Decals; Assembly; Assembling The Mower - Toro Super Recycler 20030 Operator's Manual

Safety and Instruction Decals

Safety decals and instructions are easily visible to the operator and are located near any
area of potential danger. Replace any decal that is damaged or lost.
ON MOWER HOUSING
(Part No. 43–8480)

Assembly

Assembling the Mower

Hand Push Model Only
1. Align the upper and lower handles and remove the
packing filler from between the handles with a pliers.
2. Remove the left knob and bolt then install the knob
and bolt on inside of the handle (Fig. 1).
Figure 1
1. Right handle knob
3. Tighten both handle knobs.
4. Move the handle support brackets slightly outward so
they will not be in the way when pivoting the handle
backward into the operating position (Fig. 2).
ON MOWER HOUSING
(Part No. 93–0248)
311
2. Left handle knob (before
moving it to the inside)
1. Support bracket
2. Handle stud
5. Pivot the handle backward.
6. Move the support brackets inward while positioning
the handle studs into center hole of the brackets
(Fig. 2).
Note: If handle height is not satisfactory, adjust it by
placing handle stud into a different hole.
7. If a support bracket does not fit tightly against the
handle, remove the bracket from the handle stud, bend
it inward, and attach it to handle stud.
8. Secure the cable to the upper handle with a cable tie
(Fig. 2).
9. Pull the starter rope through the rope guide on the
handle (Fig. 3).
5
ON MOWER HOUSING
(Part No. 99–6018)
m–4271
Figure 2
3. Control cable
4. Cable tie