Using The Grass Bag - Toro Super Recycler 20030 Operator's Manual

1
2
Figure 33
1. Discharge tunnel
2. Vertical bolts
4. Fasten the front right, rear right, and rear left corners
of the discharge tunnel to the mower, using the bolts
saved from step 2. Ensure that the shorter horizontal
bolt is installed in the front right location.
5. Secure the spring bracket and discharge tunnel to the
mower with the left front bolt (Fig. 34). A socket set
extension may be necessary (Fig. 35).
Figure 34
1. Spring
2. Spring bracket
Figure 35
1. Socket set extension
6. Hook the end of the spring through the small hole on
the spring bracket (Fig. 34).
3
420
3. Horizontal bolt
1
2
3
1911
3. Left front bolt
1
2
505
2. Spring bracket
7. Open and close the discharge door to ensure that the
spring is not contacting any part of the engine and that
the door closes when the handle is released.
WARNING
POTENTIAL HAZARD
Ensure that the spring does not contact the gas
tank or any other part of the engine.
WHAT CAN HAPPEN
Wear between the spring and engine parts may
result in an unsafe operating condition.
HOW TO AVOID THE HAZARD
If the spring contacts any part of engine, do not
install the bagger kit on the mower and contact
an Authorized Toro Service Dealer before
proceeding.

Using the Grass Bag

1. Stop the engine and wait for all moving parts to stop.
2. Ensure that the discharge door handle is fully forward
and the pin is engaged in the catch (Fig. 36).
1. Bag frame on retaining
post
2. Pin contacting latch plate
3. Slide the hole in the bag frame onto the retaining post
on the discharge tunnel (Fig. 36).
4. Set the rear of the bag frame onto the lower handle.
5. Open the discharge door by pulling the discharge door
handle forward until the pin clears the ramp on the bag
door and moving the handle rearward until the pin
locks in the bag notch (Fig. 37).
20
2
1
3
Figure 36
3. Handle fully
forward–discharge door
closed
1912