Folding The Handle; Removing From Storage; Accessories; Rear Grass Catcher - Toro Super Recycler 20030 Operator's Manual

7. Touch up all rusted or chipped paint surfaces. Paint is
available from an Authorized Toro Service Dealer.

Folding the Handle

IMPORTANT: Be extremely careful when folding the
handle so that you do not pull, crimp, or in any way
damage the cables.
IMPORTANT: Do not remove or loosen the knobs
securing the lower handle to the swing bracket. Do not
fold the upper handle backwards.
1. Loosen the knobs that secure the upper handle.
2. Carefully swing the upper handle forward until it rests
on the engine (Fig. 30).
Figure 30

Removing From Storage

1. Carefully unfold the upper handle until it nests with
the lower handle, then tighten the knobs.
IMPORTANT: Be extremely careful when unfolding
the handle so that you do not pull, crimp, or in any way
damage the control cables.
2. Check and tighten all fasteners.
3. Remove the spark plug (Fig. 17) and spin the engine
rapidly using the starter to blow excess oil from the
cylinder.
4. Clean the spark plug or replace it if it is cracked,
broken, or the electrodes are worn.
5. Install the spark plug and torque it to 15 ft.-lbs.
(20 N m).
6. Perform the recommended maintenance procedures.
Refer to the Maintenance section, page 11.
7. Charge the battery; refer to Charging the battery,
page 16.
8. Fill the fuel tank (Fig. 31) with fresh, clean gasoline.
1
1. Fuel tank cap
9. Check the engine oil level.
10. Connect the spark plug wire (Fig. 17).

Accessories

Accessories may have been shipped with your mower or
are available from your Authorized Toro Dealer. For
proper installation, follow these instructions.

Rear Grass Catcher

m–4217
Installing the Discharge Tunnel
Note: Determine the left and right sides of the mower by
standing behind the handles.
1. Disconnect the spark plug wire.
2. Remove and save the four bolts securing the Recycler
cover and deflector assembly to the mower (Fig. 32).
Save the parts for future use.
1
1. Bolt (4)
3. Position the discharge tunnel and door assembly on the
mower, aligning the holes in the discharge tunnel with
holes in the mower (Fig. 33).
19
Figure 31
2
503
Figure 32
2. Cover and deflector
assembly
1626