Table of Contents
Advertisement
Figure 36
1. Positive battery post
2. Negative battery post
5. Install the battery in the tractor and connect the
battery cables; refer to Installing the Battery.
Note: Do not run the tractor with the battery
disconnected, electrical damage may occur.
Servicing the Fuses
Service Interval/Specification
The electrical system is protected by fuses. It
requires no maintenance; however, if a fuse blows,
check the component/circuit for a malfunction
or short.
Fuse:
• Main F1–30 amp, blade-type
• Charge Circuit F2–25 amp, blade-type
• Optional Headlight Kit–10 amp, blade type
1. Raise the seat to gain access to the fuse holder
(Figure 37).
2. To replace a fuse, pull out on the fuse to
remove it (Figure 37).
3. Red (+) charger lead
4. Black (-) charger lead
Figure 37
1. Main–30 amp
2. Charge circuit–25 amp
Drive System
Maintenance
Checking the Tire Pressure
Maintain the air pressure in the front and rear
tires as specified. Uneven tire pressure can cause
uneven cut. Check the pressure at the valve
stem after every 50 operating hours or monthly,
whichever occurs first (Figure 38). Check the
tires when they are cold to get the most accurate
pressure reading.
Rear Tires: 13 psi (90 kPa)
Front Tires (castor wheels): 35 psi (139 kPa)
Figure 38
1. Valve stem
31
3. For optional Headlight
Kit–10 amp
Advertisement
Table of Contents
