Spektrum SPMVR2500 Instruction Manual page 7

Table of Contents

Advertisement

Available languages

Available languages

Head Tracking
Wired Head Tracking
1.
Connect the data cable (FSV1410-not
included) to the data port on the headset
and the trainer port on you transmitter.
2.
Select Wired Trainer from the Trainer menu.
3.
Change the trainer mode from Inhibit to FPV.
4.
Select the switch you wish to use for
the head tracker, then select NEXT.
5.
Select the Output Channel where the
head tracker servo is connected.
6.
Change Mode: Master to Mode: Slave.
7.
Select Input Channel.
8.
Test the head tracker movement. Move
the head tracker switch to the On posi-
tion, then move your head. The cam-
era should move accordingly.
9.
Adjust the Scale value to change the amount
of camera movement. If the camera moves
in the wrong direction, change the Direc-
tion option from Normal to Reverse.
Wired Head Tracking Menu Navigation
NOTICE: for proper head tracker operation all functions should be left in the default
state. If you are having problems with head tracking, restore the head tracker
settings to factory defaults.
To enter head tracking menu, hold the Display Button while inserting the battery and
immediately release the button after barrel insertion.
Beep code Mode
1 short beep: Pan/Tilt on ch 5/6
2 short beep: Pan/Tilt on ch 6/7
3 short beep: Pan/Tilt on ch 7/8
4 short beep: Reverse pan direction
* Press the Display Button to gain manual control of the camera with the headset.
5 short beep: Reverse tilt direction
1 long beep: Adjust servo center point*
1 short beep: Restore factory defaults
2 long beep: no selection made, auto-
matically exits menu
7
EN

Advertisement

Table of Contents
loading

Table of Contents