Table of Contents
Advertisement
Available languages
Available languages
EN
Head Tracking
The Trainer FPV function found in Spektrum Airware Radios with wireless trainer,
enables you to control FPV head-tracking in either wireless or wired mode. The default
channel asignments are:
•
CH5 Frequency
You may assign incoming head-tracker channels to any available output channel in the
transmitter.
Wireless Head Tracking
1.
Select Wireless Trainer from the Trainer menu.
2.
Change the trainer mode from Inhibit to FPV.
3.
Select the switch you wish to use for
the head tracker, then select NEXT.
4.
Select the Output Channel where the
head tracker servo is connected.
5.
Change Mode: Master to Mode: Slave.
6.
Select Input Channel.
7.
Select bind and press the scroll wheel to
put the Transmitter into bind mode.
8.
Power on the headset and it will attempt
to bind to the wireless buddy box function
in the transmitter. The Transmitter should
report DSMX 11ms after a successful bind.
9.
Test the head tracker movement. Move
the head tracker switch to the On posi-
tion, then move your head. The cam-
era should move accordingly.
10. Adjust the Scale value to change the amount
of camera movement. If the camera moves
in the wrong direction, change the Direc-
tion option from Normal to Reverse.
To adjust the camera center position:
1.
Move the headset to the desired camera center position.
2.
Press the Display Button to save the new center position.
IMPORTANT: Make sure the servos are near the center point before adjusting the
camera center position, otherwise, the servo travel may be limited.
•
CH6 Pan
6
•
CH7 Tilt
Advertisement
Table of Contents
