Connecting A Powered Subwoofer - Onkyo TX-SR403 Instruction Manual

Connecting Your Speakers—Continued
Connecting Speaker
1
Strip 3/8" (10 mm) of insu-
lation from the ends of the
speaker cables, and twist
the bare wires tightly, as
shown.
2 While pressing the lever, insert
the wire into the hole, and then
release the lever.
Make sure that the terminals are
gripping the bare wires, not the
insulation.
Note:
When speaker set B is turned on, speaker set A is reduced
to 2.1-channel playback.
The following illustration shows which speaker should be connected to each pair of terminals.
Front right Front left
speaker speaker
Speaker Set B

Connecting a Powered Subwoofer

Using a suitable cable, connect the AV receiver's SUB-
3/8" (10 mm)
WOOFER PRE OUT to an input on your powered sub-
woofer, as shown. If your subwoofer is unpowered and
you're using an external amplifier, connect the SUB-
WOOFER PRE OUT to an input on the amp.
Note:
Make sure the cable is plugged all the way.
Surround
back
speaker
LINE INPUT
Powered Surround
subwoofer right
speaker
Speaker Set A
Center
speaker
Surround Front right
left speaker
speaker
Front left
speaker
17